NEED: Single Line Font... (must be single line inside SW also, npt just MS Word)

[Ronni]

I have tried quite a few fonts but havent found one I can use yet.

CAMworks font: Letters are close to eachother, and if I manually space
them they are too far apart.

http://www.linotype.com/183979/agilitahairline-font.html
Tried the above which looks like I could use it, and it is a single
line font in MS Word... But SW adds thickness to it.

So basically I need a single line font that can be used for engraving
numbers and letters into alu/steel plates with a milling head of ø3
(smaller makes it unreadable with the unit height we are using)

[j]

I downloaded one called DPS Schrift that is a single line font. I don't
remember where I downloaded it from but found it again here

http://cz.solidcamsupport.net/index.php?_m=downloads&_a=viewdownload&downloaditemid=11&nav=0

Post by Ronni
I have tried quite a few fonts but havent found one I can use yet.
CAMworks font: Letters are close to eachother, and if I manually space
them they are too far apart.
http://www.linotype.com/183979/agilitahairline-font.html
Tried the above which looks like I could use it, and it is a single
line font in MS Word... But SW adds thickness to it.
So basically I need a single line font that can be used for engraving
numbers and letters into alu/steel plates with a milling head of ø3
(smaller makes it unreadable with the unit height we are using)

[Ronni]

Hey J

thx for posting

I already tried this font and it is very similar to the CAMworks
font.
And its the same problem, the letters are too close to another :-(