Concave or convex fillet

[samurai]

How do I create a concave fillet in SW2006?

Ex. A box. When i fillet one edge, it creates a convex fillet. I
want it to be concave instead.

Thanks,
samurai.

[Zander]

Hi,

Create a sketch profile of the box perimeter. Then create a second
sketch of an arc (radius of your concave fillet). The use the feature
cut-sweep.

There may be a better way?

Zander

Post by samurai
How do I create a concave fillet in SW2006?
Ex. A box. When i fillet one edge, it creates a convex fillet. I
want it to be concave instead.
Thanks,
samurai.

[samurai]

Can this be done without using a sketch/cut sweep? I wanted to use
the Fillet command.

If there was a 'flip direction' for the fillet command, that would be
great.

Anyone know how to do this with the Fillet Command?

samurai.

Post by Zander
Hi,
Create a sketch profile of the box perimeter. Then create a second
sketch of an arc (radius of your concave fillet). The use the feature
cut-sweep.
There may be a better way?
Zander

Post by samurai
How do I create a concave fillet in SW2006?
Ex. A box. When i fillet one edge, it creates a convex fillet. I
want it to be concave instead.
Thanks,
samurai.

[Jerry Steiger]

"take the garbage out, dear"

Post by samurai
Can this be done without using a sketch/cut sweep? I wanted to use
the Fillet command.
If there was a 'flip direction' for the fillet command, that would be
great.
Anyone know how to do this with the Fillet Command?

If you are working with surfaces you can pick which side of the each surface
you want the fillet to be on.

I don't understand your original question, as a concave fillet on a box
doesn't make any sense to me.

Jerry Steiger
Tripod Data Systems